# Motorcycle Helmet Lock Keys: Factory Holders and Add-Ons

Source: https://themotorcyclelocksmith.com/san-diego/guides/motorcycle-helmet-lock-keys/

Business: The Motorcycle Locksmith, mobile motorcycle locksmith. Phone and text: (619) 775-1858 (San Diego side).

> Most factory helmet holders use the ignition key, either directly in a small lock on the side of the bike or indirectly, because the helmet hangs on a hook that the locked seat or trunk traps. Add-on helmet locks are separate products with their own key or combination. So a lost helmet lock key on a stock bike is usually a lost ignition key problem, and a new key cut to the bike's code works the holder too.

## The main kinds of factory helmet holder

Owner's manuals describe a handful of designs, and knowing which one you have tells you which key matters.

| Design | How the manual says it works | Examples |
| --- | --- | --- |
| Keyed holder on the frame | Insert the ignition key, turn to unlock, hang the helmet on the holder pin, push the pin in, remove the key | Honda Shadow Aero VT750C and XR650L manuals |
| Hook or post under the seat | Open the seat, hang the helmet ring on the hook, close the seat to lock it | Kymco Agility and X-Town scooters, Yamaha XJ6 |
| Helmet wire under the seat | Run the supplied wire through the helmet D-ring, hook its loops on the holder, refit the seat | Honda CBR600RR |
| Holders inside a trunk | Open the trunk, turn a knob inside to release the holders, hang the helmets, push the holder in | Honda Gold Wing GL1800 |

## Keyed holders that share the ignition key

On bikes with a dedicated helmet lock, Honda's manuals are explicit that it takes the ignition key. The 2006 Shadow Aero manual says to insert the ignition key and turn it counterclockwise to unlock the holder, hang your helmet on the holder pin, push in on the pin and remove the key. The XR650L manual uses the same words. Some Hondas combine the helmet holder with the seat lock in one cylinder, and the manual for those tells you to lift the seat afterward to confirm it locked.

Because this lock is cut to the same key as the ignition, there is no separate helmet lock key to lose on a stock bike. If your helmet holder needs a different key from the ignition, a previous owner has replaced one of the two, and they can be brought back to one key.

## Holders that rely on the seat or trunk lock

Sport bikes and scooters often have no helmet lock at all. The 2010 CBR600RR manual has you remove the rear seat, route the helmet holder wire from the tool kit through the helmet's D-ring, hook the wire's loops onto the holder and install the rear seat to lock it. Yamaha's XJ6 manual likewise puts the holder under the seat with a helmet holding cable in the tool kit. On a used bike, check the tool kit, because the holder is of little use if that wire or cable has gone missing.

Scooters do the same with posts. Kymco's Agility manual describes two helmet posts under the seat: with the seat up, put the helmet's retaining ring on the post, then lower and press the seat to lock it. The Gold Wing puts its holders inside the travel trunk, released by a knob in the trunk. In all of these, the lock protecting your helmet is the seat lock or trunk lock, so a seat that will not open is what stands between you and the helmet.

**Rather have us handle it?** Call or text with your year, make, model and location. Call or text (619) 775-1858.

## Use it parked, not riding

Owner's manuals carry the same warning. Honda puts it most strongly: riding with a helmet attached to the holder can interfere with the rear wheel or suspension and could cause a crash, so use the helmet holder only while parked. Kymco says not to ride with a helmet hanging from a helmet post. A helmet lock also only secures the D-ring or strap, so it stops a casual grab and little more. Treat it as a convenience for short stops.

## Add-on helmet locks

If your bike has no holder, or you carry a second helmet, add-on locks fill the gap. They come in two broad types: keyed locks that clamp to a handlebar, frame tube or license plate bracket, and combination locks, often a carabiner shape with or without a cable. A keyed add-on lock has its own key that has nothing to do with your ignition key, so it needs its own spare. A combination lock has no key to lose, but a forgotten code leaves you in the same place.

Replacement key terms vary from maker to maker. Look on the packaging or the keys for a key number when the lock is new, and keep it with your bike paperwork.

## Stuck holder or lost key

A keyed helmet holder is one of the least used and most exposed locks on a motorcycle, which is why it tends to seize before anything else. If the ignition key goes in but will not turn, do not lean on it. A bent or snapped key in a helmet lock turns a small job into two. A little dry lock lubricant and a gentle try with your least worn key is as far as it is worth going on your own. Our salt air guide covers why little-used locks seize.

The usual cases look like this.

- Ignition key lost with the helmet locked to the bike: a new key made for the bike also opens a matching holder, so one visit solves both.
- Holder seized with the helmet on it: the lock is opened and serviced or replaced, without damage to the helmet where possible.
- Holder has a different key from the ignition and that key is lost: a key is made for it, or it is rekeyed to your ignition key, after a check of photo ID and registration or title.
- Seat will not open with a helmet hooked underneath: this is a seat lock or cable fault, covered in our stuck lock guide.
- Add-on lock with a lost key and the helmet attached: we open or remove it once we have seen photo ID and the bike's registration or title.

## Quick questions

### Does the helmet lock use the same key as the ignition?

On a stock bike, normally yes. Honda's manuals, for example, tell you to insert the ignition key in the helmet holder, and under-seat hooks are secured by the seat lock, which also uses the ignition key.

### My sport bike has no helmet lock. Where is it?

Check under the rear seat. The Honda CBR600RR manual describes a helmet holder there, used with a wire supplied in the tool kit, and the seat locks it in place.

### Can I ride with the helmet on the holder?

No. Honda and Kymco manuals both say to use the helmet holder only while parked, because a hanging helmet can interfere with the wheel or suspension.

### The helmet holder has a different key from my ignition. Can that be fixed?

Usually. A helmet lock can often be rekeyed or replaced so it works with your ignition key again.

## Services that can help

- [Gas Cap, Seat, Steering and Saddlebag Locks](https://themotorcyclelocksmith.com/san-diego/services/motorcycle-lock-repair/): Gas cap, seat, steering, helmet and saddlebag locks.
- [Lost Motorcycle Key, No Spare](https://themotorcyclelocksmith.com/san-diego/services/lost-motorcycle-key/): No key at all? We make a working key at the bike.
- [Broken Motorcycle Key Extraction](https://themotorcyclelocksmith.com/san-diego/services/broken-key-extraction/): Snapped key removed and a new one cut from the pieces.

## Key details by make

[Honda keys](https://themotorcyclelocksmith.com/san-diego/makes/honda/), [Yamaha keys](https://themotorcyclelocksmith.com/san-diego/makes/yamaha/), [All makes](https://themotorcyclelocksmith.com/san-diego/makes/)

## Keep reading

- [Motorcycle Gas Cap, Seat or Steering Lock Stuck? What to Do](https://themotorcyclelocksmith.com/san-diego/guides/motorcycle-gas-cap-seat-or-steering-lock-stuck/): Stuck gas cap, seat and steering locks on motorcycles usually come down to grime or corrosion in an exposed cylinder, a worn key, a stretched seat cable, or parts under tension that hold the latch closed.
- [Scooter Seat and Storage Locks: How They Open and Fail](https://themotorcyclelocksmith.com/san-diego/guides/scooter-seat-and-storage-locks/): Scooters open the seat in one of three basic ways: a separate seat lock that takes the ignition key, a seat position on the ignition switch, or an electric button or keyless fob.
- [Corroded Motorcycle Locks From Salt Air: Signs and Care](https://themotorcyclelocksmith.com/san-diego/guides/corroded-motorcycle-locks-salt-air/): Salt air corrodes the small parts inside ignition, seat and fuel cap locks, and the first signs are a gritty key, a lock that needs a second try, or a little-used lock that stops working.
- [Lost the Key to Your Motorcycle Disc Lock or Chain?](https://themotorcyclelocksmith.com/san-diego/guides/lost-key-to-motorcycle-disc-lock-or-chain/): Start with the lock maker: most quality disc locks and chains come with a key number or code, and makers such as Kryptonite and Xena supply replacement keys against it.
- [Lost Givi, SHAD or Kappa Top Case Key: Your Real Options](https://themotorcyclelocksmith.com/san-diego/guides/givi-shad-kappa-top-case-lost-key/): Neither Givi nor SHAD will cut you a key once every key is lost.

## Where we work

[San Diego County](https://themotorcyclelocksmith.com/san-diego/service-areas/san-diego-county/), [San Diego](https://themotorcyclelocksmith.com/san-diego/service-areas/san-diego-county/san-diego/), [Chula Vista](https://themotorcyclelocksmith.com/san-diego/service-areas/san-diego-county/chula-vista/), [Oceanside](https://themotorcyclelocksmith.com/san-diego/service-areas/san-diego-county/oceanside/), [Escondido](https://themotorcyclelocksmith.com/san-diego/service-areas/san-diego-county/escondido/), [Carlsbad](https://themotorcyclelocksmith.com/san-diego/service-areas/san-diego-county/carlsbad/), [El Cajon](https://themotorcyclelocksmith.com/san-diego/service-areas/san-diego-county/el-cajon/), [All service areas](https://themotorcyclelocksmith.com/san-diego/service-areas/)